Mitel 300 Installation And Maintenance Manual page 37

Installation and connection
1. Open the MDF Cover of the CCU
2. Remove the MOH Module from packaging
3. Ensure clear access to the MOH fitting position (as below)
4. Remove Adhesive Backing paper from MOH Module
5. Fit MOH Module using Adhesive Pad in area shown
6. Fit with cables exiting to Right Side as shown below
7. Route Extension cable to preferred extension on the CCU or Expansion module
8. Connect cable to AB port on extension using KRONE tool
9. Route the 3.5mm Stereo Jack connector to the Music Source external to the system, and
connect source.
10. Complete any cabling and close the MDF.
11. Program the External MOH Extension Source
11.1 Programming / System
11.2 Music on Hold / Select External Source
11.3 Select "External MOH Position"
Confirm operation and audio levels are satisfactory
Mitel 3000 Australia Installation and Maintenance Manual
36