Wall-Mounting A Feature Phone - Mitel 300 Installation And Maintenance Manual

Wall-mounting a Feature phone

The phone plinth is inverted on the base to wall mount the phone.
Locate, drill and plug the 2 screw locations as shown below. The holes should be deep
enough to accept a 2.5 cm screw. Insert the two screws leaving sufficient space to clip the
base over them. Locate the phone and base over the screws.
Featurephone in
Wall Mount
position
Mitel 3000 Australia Installation and Maintenance Manual
Line cord rails
150 mm
Screws
31
Sixteen Key and
Console in Wall Mount
position