Local Area Network (Lan) Ethernet - SATO /s8408 Operator's Manual

LOCAL AREA NETWORK (LAN) ETHERNET

A Local Area Network (LAN) interface is an optional Plug-In Interface Module that can be installed by the user. It
requires a driver shipped with each printer that has the interface installed. The driver that must be loaded onto the
host computer and configured to run one of the supported network protocols using a 10Base-T or 100Base-TX
LAN connection. Details for loading the LAN driver are contained in the LAN Interface Manual that is shipped with
each printer with a LAN Optional interface installed.
SPECIFICATIONS
Connector
Cable
Cable Length
Power Supply
Protocol
IP Address
Subnet Mask
Gateway Address
DIP SWITCH SETTINGS
SWITCH
1
2
3
4
SOFTWARE SPECIFICATIONS
Corresponding Protocol
Network Layer
Session Layer
Application Layer
NOTE: Print data can be sent by LPR and FTP of TCP/IP and dedicated socket protocol. Printer status is obtainable by ded-
NOTE: In the TCP/IP protocol environment, LPD and FTP are provided for printing; TELNET for variable setup; ARP, RARP,
LPD protocol complies with RFC1179 and handles the list of logical printer name as queue name such as lp, sjis, euc. In
When sending the job by LPR, the transmission order of data file/control file within the job will not affect print operation. In
addition, if the banner page is specified, it will be added to each data file. Job deletion by LPR is not available.
FTP protocol complies with RFC959 and handles the list of logical printer name as a transfer directory. File transfer to this
directory executes print operation. It is possible to specify ASCII(A), Binary(I) and TENEX(L8) as transfer mode - although
the mode difference is dependent on the client. A banner page may be printed with a proper setup.
TELNET Complies with RFC854. This operation consists of interactive menu form and enables change and reference of
internal setup, and to display status. To change the setup, enter "root" user and password at the time of login. Default of root
S8400 Series Operator Manual
Unit 3: Installation
SETTING
LAN board EEPROM initialization (configuration).
Print a self-diagnosis of the board onto a label.
icated socket protocol.
and BOOTP/DHCP for address setup.
addition, a banner page can be printed by a proper setup.
password is set as null (linefeed only).
RJ-45 Receptacle
10BASE-T, 100BASE-TX
100 meters or less
Powered from printer
Status3 return
Status4 (cyclic response mode)
Status4 (ENQ response mode)
Status4 return
Status5 return
0.0.0.0 to 255.255.255.255
0.0.0.0 to 255.255.255.255
0.0.0.0 to 255.255.255.255
Reserved (setup prohibited).
Print configuration details on a label.
TCP/IP
ARP, RARP, IP, ICMP
TCP, UDP
LPD, FTP, TELNET, BOOTP, DHCP
3-14 PN: 9001160 (C)