SATO /s8408 Operator's Manual page 96

MENU
EMULATION SELECT
AUTO MANUAL
EMULATION SELECT
SATO STANDARD
SZPL EMULATION
SIZE MODE
CMD AUTO LCD
TEAR OFFSET
U: +0000
HEAD CHECK
LABEL 0000
PROTOCOL
NONE ACK ZEBRA
LAN PASSTHRU
ENABLE DISABLE
RS485 NETWK ID
ID 000
COMM DIAG
OFF ON
S8400 Series Operator Manual
Unit 4: Printer Configuration
SZPL EMULATION MODE (TABLE 4-23)
Emulation mode select
AUTO or MANUAL. Default value is AUTO.
←, →
Select AUTO or MANUAL
↓, ↑
Select SATO STANDARD or SZPL EMULATION.
←, → Select CMD or AUTO or LCD.
Tear Offset Position
Range is -999 to +999. Default value is +0
←, →
Select between sign (+/-) and numeric value
↓, ↑
Change the select setting
Head Check
Range 0000-9999. Default value is 0000 (i.e. disabled)
↓, ↑
Select 0000-9999
SZPL Communication Protocol
NONE, ACK or ZEBRA. Default value is NONE
←, →Select NONE, ACK or ZEBRA
Note: When the protocol is set to ACK, the status will be returned back to host (ACK/NAK) in
every command execution. When protocol set to ZEBRA, the status will be returned back to host
when LAN interface is used.
LAN Passthru
ENABLE or DISABLE. Default is DISABLE
←, → Select ENABLE or DISABLE
ENTER: Accept setting and advance to next menu
CANCEL: Disregard setting and revert back to previous menu
RS-485 Network ID
Range 000-999. Default value is 000 (i.e. unused)
↓, ↑
Select 000-999
Communication Diagnostics (i.e. Hex Dump Mode)
Default value is OFF
←, →
Select OFF or ON
DESCRIPTION
4-50 PN: 9001160 (C)