SATO /s8408 Operator's Manual page 121

ADJUSTMENT OF HEAD POSITION, (Cont'd)
Front - Rear pressure balance (longitudinal position, forward and backward/alignment)
Lock the print head in position. Locate the area represented in the figures below.
1.
Loosen the screws indicated in Figure 6-10 with Phillips screwdriver. Do not completely unscrew.
2.
Insert slotted screwdriver into the holes on the left and the right sides and adjust the head position by turning
3.
the screwdriver in the relevant direction.
Direction A: Head position moves forward.
Direction B: Head position moves backward.
Tighten the screw loosened in Step 2.
4.
B
A
Screw
Figure 6-10, Print Head Adjustment, Enlargement of Portion of Figure 6-9
S8400 Series Operator Manual
Unit 6: Maintenance
Figure 6-9, Print Head Adjustment, Front - Rear Balance
Insert slot screwdriver here
6-9
B
A
Screw
PN: 9001160 (C)