SATO /s8408 Operator's Manual page 91

MENU
CAL. START
YES NO
RFID TAG OFFSET
XX MM
ANTENNA POWER
50.1mW XX.XdBm
MENU
SELECT SHIFT
1 2 3 EXIT
ENTER SHIFT TIME
XX.XX
HOW MANY CHR?
X-XX
ENTER SHIFT NAME
X
MENU
LABEL OUT SENSOR
YES NO
S8400 Series Operator Manual
Unit 4: Printer Configuration
RFID USER MODE (TABLE 4-12)
Allows the initialization of calibration. Ensure the printer is loaded with the intended
media to be calibrated. Use the printer's operator panel to scroll and select the desired
option.
Setting the RFID tag position from the top of form.
The input range is between 0.79" (20 mm) and 9.45" (240 mm).
The initial value is 0.79" (20 mm).
The measurement units are millimeters.
Allows for the determination of the antenna's reception power when calibrating.
WORK SHIFT MODE (TABLE 4-13)
This screen is used to select the shift that will be configured in the screens to follow. Up to three
shifts can be configured.
Note the shift code must be installed from within the Hidden Mode (below) to access the Work
Shift Mode.
Permits the entry of the begin time of the shift being configured. This is in a 24 hour clock format.
Allows the establishment of the quantity of character to be used for the Shift Name in the screen
to follow. The first X depicts the shift number and is based upon what was selected in the Select
Shift screen. The XX has a valid range of 1 to 16.
Allows the entry of the user defined shift name. The quantity of characters used must be
reflective of the quantity entered in the preceding screen.
HIDDEN MODE (TABLE 4-14)
Used to enable or disable the label out sensor. The YES option is enabled and the NO option is
disabled.
DESCRIPTION
DESCRIPTION
DESCRIPTION
4-45 PN: 9001160 (C)