SATO /s8408 Operator's Manual page 75

MENU
MODE SELECT
XML SBPL
ROTATE LABEL
DEG 0 180
LABEL SIZE ADJ
WIDTH: XXXX
LABEL SIZE ADJ
HEIGHT: XXXX
MENU
INTERFACE MODE
INTERFACE BOARD
SETTING
YES NO
DATA PORT
I / F – 1 I / F - 2
IGNORE CR/LF
YES NO
INTERFACE BOARD
SETTING
I / F – 1 I / F - 2
S8400 Series Operator Manual
Unit 4: Printer Configuration
ADVANCED MODE (TABLE 4-2)
This menu screen allows the setting of the printer in either SBPL mode or XML mode.
This menu screen allows the printing of label either in a programmed orientation or rotated 180
degrees from the programmed orientation.
This menu screen allows the setting of label width in dots. This is used in conjunction with Rotate
Label setting and SZPL mode.
The setting range and default value varies depending on the print density of the printer.
(8 dot/mm) Default value: 832
(12 dot/mm) Default value: 1248 Setting range:0000~1248
(24 dot/mm) Default value: 2496 Setting range:0000~2496
This menu screen allows the setting of label length in dots. This is used in conjunction with
Rotate Label setting and SZPL mode.
The setting range and default value varies depending on the print density of the printer.
(8 dot/mm) Default value: 20000 Setting range: 0000~20000
(12 dot/mm) Default value: 18000 Setting range: 0000~18000
(24 dot/mm) Default value: 9600
PARALLEL INTERFACE MODE (TABLE 4-3)
Is the premiere screen of the Interface Mode. The Interface Mode allows the parameters to be set
for the printer to communicate with a host and vice-versa.
Select the YES option to configure an interface board for bi-directional communication, the menu
will advance to multiple configuration screens depending on the type of interface board installed.
Selecting the NO option will bypass those screens.
Allows the selection of which interface port will be assigned to receive print data. Interface Port 1
(I/F-1) is not in use. Interface Port 2 (I/F-2) is the printer's middle card slot. The default setting is
I/F-2 and accommodates a standard interface card.
Determines whether the print data code requires deletion. Hexadecimal graphic data will not be
deleted. Select YES to delete all Carriage Returns (CR) and Line Feed (LF) commands in the
data stream - including graphics and 2D bar codes. Select the NO option to process them.
This feature is primarily used to maintain compatibility with earlier models of SATO printers.
Allows the selection of which interface board will be set up in subsequent menus. Interface Port 2
(I/F-2) is the printer's middle card slot. The default setting is I/F-2 and accommodates a standard
interface card. I/F-1 is not in use.
DESCRIPTION
Setting range:0000~0832
Setting range: 0000~9600
DESCRIPTION
4-29 PN: 9001160 (C)