Installation Of Receiver - Salus T105 RF Instruction Manual

4 5
- 2 AA size alkaline batteries (not included)
- Slim housing design
- EL backlight
Receiver:
- Linked with Control Centre via RF.
- Power control rating up to 230VAC 16A
resistive.
- Powered by line voltage only. No battery
required.
- Two LED indicators for power and output status.

INSTALLATION OF RECEIVER

Caution :
1. The appliance can only be mounted indoors
and in areas free from any water or moisture
2. A suitable fuse with a rating not exceeding
13A, should be in the power line.
3. Observe the nation regulator for the wiring.
4. A qualified electrician is recommended for
installation and servicing.
This thermostat has been designed for simple and
quick installation requiring only a few tools. Only the
Power Control Unit needs to be installed.
Required Tools
• Hammer • Masking tape • Screwdriver
• Drill and 3/16" drill bit (if not installed on a
junction box)
RF Address Code Setting
If there is another user nearby, e.g. in the next
house, your receiver may be fault triggered by their
transmitter. You may select a different RF address
code to prevent this. Receiver can only response to
RF coding with the same address code setting as its
own address code.
1. To adjust address code of Receiver, simp
push up one or more of the 5 dip switch
levers.
2. To adjust address code of Control Centre
the housing of the transmitter unit. See
replacement section on how to open the
3. Remove one or more of the jumper caps
shown in the diagram below.
Caution :
1. Address code of Control Centre must be
same as address code of Receiver. For an
jumper cap removal of address code # in
Control Centre, the same address code #
Receiver must be put to the UP position
2. Disconnect AC power and remove batte
prior to adjusting address code.
6 7
Remove one
the jumper ca
RF address co
Address code
left to right