Choosing Location; Mounting Receiver Onto Wall/Junction Box; Optional Wall Box - Salus T105 RF Instruction Manual

WARNING: After removing the wall plate, if you
find that it is mounted on a junction box (e.g. a box
similar to one behind a light switch or electric
outlet), high voltage circuit may be present and
there is a danger of electric shock. Please consult a
qualified electrician.
Choosing a Location
Note: for a new installation, choose a mounting
location about five feet (1.5 metre) above the floor
in an area with good air circulation and away from.
1. Drafts.
2. Air ducts.
3. Radiant heat from the sun or appliances.
4. Concealed pipes and chimneys.
Mounting the Receiver onto the
wall/junction box:
1. Remove the front cover of the Receiver. (go to
step 4 if installed on a junction box)
2. Mark the holes position.
3. Drill two holes and insert the plastic anchors
carefully into the holes until they are flush
with the wall.
8 9
4. Connect the wires - see wiring diagram.
5. Push on the wires in the wall.
6. Securely fasten the Receiver to the wall with the
two screws.
7. Replace the front cover and installation is
completed.
Mounting the Receiver onto the

optional wall box :

1. Remove the front cover of the Receiver.
2. Mark the holes position for the wall box.
3. Drill two holes and insert the plastic anchors care
fully into the holes until they are flush with the
wall.
4. Pull the wires into the wall box and fasten the
wall box onto the wall.
5. Connect the wires - see wiring diagram.
6. Push on the wires in the wall box.
7. Securely fasten the Receiver to the wall box with
the two screws.
8. Replace the front cover and installation is
completed.
10 11
WIRING DIAGRAM
FOR 230V APPLICATION
The unit is default 230V, if volt f
required you must remove link &
below.
SL (Off) - Heat Off
L - Live
SL (On) - Heat On
N - Nuetral
It is vital to connect the live into
avoid overloading of the jump w