Removing Old Thermostat; Choosing A Location - Salus T105 RF Instruction Manual

1. To adjust address code of Receiver, simply
push up one or more of the 5 dip switch
levers.
2. To adjust address code of Control Centre, open
the housing of the transmitter unit. See battery
replacement section on how to open the housing.
3. Remove one or more of the jumper caps as
shown in the diagram below.
Caution :
1. Address code of Control Centre must be the
same as address code of Receiver. For any
jumper cap removal of address code # in
Control Centre, the same address code # of
Receiver must be put to the UP position.
2. Disconnect AC power and remove batteries
prior to adjusting address code.
6 7
Push up one or
more of the
white levers to
adjust Receiver
address code.
Address code # 1
- 5, from left to
right.
Removing your old thermostat
CAUTION : to avoid electric shock, isolate the power
of the heating/cooling system at the main power box
in your home. Read the following instructions careful-
ly before disconnecting the wires.
1. Turn off your old thermostat.
2. Remove the cover from the old thermostat.
Remove one or more of
the jumper cap to adjust 3. Unscrew the old thermostat from the wall plate.
RF address code.
4. Now find the screws attaching the wall plate to
Address code # 1 - 5, from
the wall, and remove them. You should now be
left to right
able to pull the wall plate a small distance from
the wall. Do not disconnect any wire yet, simply
locate the wires.
WARNING: After removing the wall plate
find that it is mounted on a junction box (e
similar to one behind a light switch or elect
outlet), high voltage circuit may be presen
there is a danger of electric shock. Please co
qualified electrician.

Choosing a Location

Note: for a new installation, choose a moun
location about five feet (1.5 metre) above t
in an area with good air circulation and aw
1. Drafts.
2. Air ducts.
3. Radiant heat from the sun or appliances.
4. Concealed pipes and chimneys.
Mounting the Receiver onto th
wall/junction box:
1. Remove the front cover of the Receiver. (
step 4 if installed on a junction box)
2. Mark the holes position.
3. Drill two holes and insert the plastic anc
carefully into the holes until they are flus
with the wall.
8 9