Connecting The Autoscope Lens Transport Motor To The Projector - Runco XtremeProjection X-200i Installation & Operation Manual

Install Lens Motor:
1. Position the AutoScope lens motor as shown in Figure 3-7.
2. Line up the mounting holes on the lens motor housing with those on the underside of
the projector.
3. Secure the motor to the projector with the eight (8) supplied M6 x 12mm Pan-Head
Phillips screws.
Install Ceiling Mount Adapters/Projector Stands: For ceiling installations, the
adapters bring the attachment points for the projector mounting rails (included with the
projector ceiling mount kit) from the bottom of the projector above and behind the
AutoScope lens motor housing. For floor installations (where the projector is upright), the
adapters allow the projector to lie flat on the mounting surface.
Using six (6) each of the supplied, Pan-Head Phillips screws, attach the AutoScope
Ceiling Mount Adapters/Projector Stands to the projector as shown in Figure 3-7.
DO NOT OVER-TIGHTEN THE SCREWS.
Caution
Connecting the AutoScope Lens Motor to the Projector: Connect the AutoScope
lens transport motor to a 12-volt trigger output on the projector, as shown in Figure 3-8.
WIRED REMOTE WIRED REMOTE
REMOTE REMOTE WIRED WIRED
I II
12V TRIGGER
TRIGGER 12V
3D SYNC 3D SYNC
SYNC SYNC 3D 3D
3.5-mm
mini plug
+12V Power
Trigger Input Switch
AuptoScope Lens Transport Motor
Figure 3-8. Connecting the AutoScope Lens Transport Motor to the Projector
After you have installed the AutoScope lens motor, proceed with Mounting the X-200i
(page 28).
Runco X-200i Series Installation/Operation Manual
RS-232 RS-232 USB USB
RS-232 RS-232 USB USB
HDMI 1 HDMI 1 HDMI 2 HDMI 2 RGB RGB
1 1 HDMI HDMI 2 2 HDMI HDMI RGB RGB
AC Input
COMPONENT 1 COMPONENT 1
1 1 COMPONENT COMPONENT
Y Y Pb Pb Pr Pr
Y Y Pb Pb Pr Pr
COMPONENT 2 COMPONENT 2
2 2 COMPONENT COMPONENT
25
Installation