Installing The Optional Cinewide With Autoscope Lens Motor; Remove Projector Front Feet; Install Anamorphic Lens Motor - Runco Signature Cinema SC-50d Series Installation & Operation Manual

Installation
3.5
Installing the Optional
CineWide with
AutoScope Lens Motor
Remove Projector Front
Install Anamorphic Lens
Downloaded From projector-manual.com Runco Manuals
If you are installing a standard SC-50d/SC-60d (without an anamorphic lens), skip this
step and proceed with Mounting the SC-50d/SC-60d (page 27).
If you are installing an SC-50d/CineWide with AutoScope or SC-60d/CineWide with
AutoScope, proceed as follows to install the lens mount/motor assembly.
Note
Place the projector upside down on a blanket or other soft surface. Loosen and remove
Feet the two front feet on the projector.
Line up the eight mounting holes on the lens motor housing with those on the bottom of
the projector. Secure the motor to the projector with the eight screws provided for this
Motor
purpose. See Figure 3-7. Then, connect the +12V trigger input on the motor to a +12V
trigger output on the
Figure 3-7. Attaching the AutoScope Lens Motor to the Projector
Caution
1. Do not install the CineWide lens yet, only the AutoScope lens
motor. You will install the CineWide lens after you install the
projector and adjust the primary lens.
2. Some components shipped with your projector may differ slightly
from what is shown in these instructions.
3. The anamorphic lens mounting kit is partially pre-assembled at
the factory – the AutoScope lens motor and lens mounting
assemblies are both fully assembled.
as shown in Figure 3-18.
DHD Controller
DO NOT OVER-TIGHTEN THE SCREWS.
26 Signature Cinema™ SC-50d/SC-60d Installation/Operation Manual