Connecting 12-Volt Trigger Output To External Theater Equipment; Connecting The 12-Volt Trigger Output To The Autoscope Lens Motor; Connecting The 12-Volt Trigger Output To Other Equipment - Runco RS-900 Owner's Operating Manual

If you are installing an RS-900/CineWide with AutoScope, use the cable supplied with the
AutoScope Lens Motor to connect the motor to the 12-volt trigger output as shown in
Figure 3-15.
Figure 3-15. Connecting the 12-Volt Trigger Output to the AutoScope Lens Motor
If your home theater contains a retractable screen, screen mask or other 12-volt
trigger-activated equipment, connect it to the 12-volt trigger output as shown in Figure
3-16.
to other,
12-volt
trigger-activated equipment
(screen, screen mask etc.)
Figure 3-16. Connecting the 12-Volt Trigger Output to Other Equipment
Runco RS-900 Owner's Operating Manual
S-VID /
3.5-mm
mini plug
AutoScope
Lens Motor (Rear)
Power
AC Input
Switch
Black = Ground (Sleeve)
Red = +12V (Tip)
S-VID /
3.5-mm
mini plug
33
Installation
Connecting 12-Volt
Trigger Output to External
Theater Equipment