Runco XtremeProjection X-200i Installation & Operation Manual page 88

Operation
You can also perform various diagnostic tasks, such as displaying test patterns, from this
menu.
System Information: Select System Information from the Service menu to view
information that uniquely identifies your projector: its Model Name, Serial Number,
installed Software Version and FPGA Version.
Should you ever need to contact Runco Technical Support, this information will help them
answer your questions and/or resolve product performance issues.
Factory Reset: Select Factory Reset from the Service menu to restore all projector
settings – except those listed below – to their factory-default values:
• Lamp Hours
• Custom 1 / Custom 2
• ISF Day
• ISF Night
• Model Name / Serial Number
• Language
Blue Only: This feature removes all red and green color information from the image, and
is useful for color-calibrating the projector or other video components.
Test Patterns: The X-200i has numerous internal test patterns that are useful to
technicians for advanced calibration, measurement and fault isolation purposes. To
access them, select Test Patterns from the Service menu and set it to On.
The available test patterns are:
• White
• Black
• Red
• Green
• Blue
• Cyan
• Magenta
• Yellow
• ANSI Checkerboard
• Horizontal Gray Ramp
• Focus Grid
Press or on the remote control unit or system keypad to cycle through the test
patterns.
The OSD menus are not available when in "test pattern" mode.
Note
To turn test patterns off, press any key other than or on the remote control unit or
system keypad.
72 Runco X-200i Series Installation/Operation Manual