Image - Runco XtremeProjection X-200i Installation & Operation Manual

• 1080p24 Output: This control selects how 24Hz 3D content will be processed in an
active 3D system. This lower frame rate can lead to excessive flickering, creating a
need for frame rate conversion (FRC). Choose one of the following:
• 96Hz employs a 2:2 cadence.
• 144Hz uses a 3:3 cadence.
Due to bandwidth restrictions, the 144Hz mode only provides 1004
Note
lines. The unused lines are set to black and evenly subtracted from
the top and bottom of the image.
• 3D Test Pattern: Choose 3D Test Pattern from the 3D Control menu and set it to On
to display the 3D test pattern (refer to Test Patterns on page 72) while adjusting these
settings.
Input Select: To select a video source, press
the or button to select a source. The default source selection is HDMI 1.
Resync: If the projected image becomes unstable or degraded, press
Resync, then press ENTER. This causes a re-acquisition of the active source. It also
changes any Fine Sync settings (described on page 66) for this timing to the default
setting.
Use the controls in the Image menu, shown in Figure 4-4, to perform advanced image
adjustments.
Figure 4-4. X-200i Image Menu
Runco X-200i Series Installation/Operation Manual
or to highlight Input Select, then use
or
59
to highlight

Image

Operation