Runco XtremeProjection X-200i Installation & Operation Manual page 58

Installation
Configure Lens Motor Trigger (CineWide with AutoScope):
CineWide with AutoScope maintains constant image height independent of the aspect
ratio, while using the full display resolution of the projector. It accomplishes this by moving
the anamorphic lens in front of the primary lens when widescreen material is being viewed.
When the viewer transitions back to 16:9 or 4:3 source material, the anamorphic lens
moves out of the light path.
To configure the lens motor trigger on the X-200i for proper AutoScope operation:
1. Project a 2.35:1 aspect ratio test pattern or other image on the screen.
2. On the X-200i remote control or system keypad, press MENU.
3. Select CONTROL from the Master Menu.
4. If you connected the AutoScope lens motor to the TRIGGER II output (as shown in
Figure 3-8), confirm that the Trigger 2 setting is AutoScope. (This is the default
setting.) Change it if necessary. If you connected the AutoScope lens motor to the
TRIGGER I output, change the Trigger 1 setting to AutoScope.
5. Select CineWide from the Control menu and set it to AutoScope.
6. Select the Cinema or Virtual Cinema aspect ratio to move the anamorphic lens into
position, if it isn't already. To do this, press CINEMA or V-CINE on the X-200i remote
control.
7. Proceed as described in the following sections to adjust the anamorphic lens.
Horizontal Position (X) Adjustment:
1. Project a white field on the screen.
2. Loosen the Yaw/X-Adjustment Levers underneath the lens.
3. Slowly move the anamorphic lens into place (from right to left or vice versa) so that
there are no shadows on either side of the screen:
Too Far Left
Too Far Right
4. When the horizontal position is properly set, tighten the Yaw/X-Adjustment Levers to
secure the lens in place.
42 Runco X-200i Series Installation/Operation Manual
Correct position