Runco XtremeProjection X-200i Installation & Operation Manual page 100

External Control
Table 6-1. Serial Command Key Names and IR Codes (continued)
RS232 Remote
Keyname Button
(none)
Operations Commands: Operations commands allow more flexible and direct control of
the projector. The syntax for operations commands is as follows:
op <operation> <command>[CR]
(Precede <operation> and <command> with a space.)
The command type can be one of three functions:
Operations Control Commands
Function Command
= <value>
Set
Get
(none)
Execute
Table 6-2 lists the valid operations commands. For Set and Get functions, the response
from the projector is ACK: followed by the command and = <value> where <value> is
the current value or ERR:NA if the value is not available. For Execute functions the
response is ACK: followed by the command. All responses are in UPPERCASE.
Some operations command examples:
Input: op bright ? [CR]
Response: ACK:BRIGHT = 100 [CR]
Input: op bright = 127 [CR]
Response: ACK:BRIGHT = 127 [CR]
Input: op resync [CR]
Response: ACK:RESYNC [CR]
Input: op input = 0 [CR]
IR Code
Set 1 Set 2
0xB0 0xF0 Apply VIrtual Cinema aspect ratio to the
active source.
0xAC 0xEC Toggles between power on and power off.
0xAD 0xED Activates remote backlighting only when
pressed momentarily.
0xB1 0xF1 Switch to 3D Auto mode.
0xB2 0xF2 Switch to 3D Side-by-side mode.
0xB3 0xF3 Switch to 3D Top-and-bottom mode.
Action on unit
Makes the unit take that value.
?
Asks what the current value is.
Performs an action such as a reset.
84 Runco X-200i Series Installation/Operation Manual
Description