Runco XtremeProjection X-200i Installation & Operation Manual page 95

Table 5-1. Troubleshooting Chart (continued)
Symptom
Colors in the image are
swapped; for example, reds
appear blue or vice versa.
ISSUE LED is flashing red
(one short flash).
ISSUE LED is flashing red
(two short flashes).
ISSUE LED is flashing red
(four short flashes).
ISSUE LED lights solid red.
When displaying 3D content,
crosstalk or "ghosting" can be
seen — that is, the left eye is
perceiving some of what the
right eye should be seeing or
vice versa.
With 3D glasses, image per-
spective is reversed — that is,
"left-eye" frames appear in the
right lens and vice versa.
3D glasses do not work.
Note: You can obtain more detailed information about the cause of the error condition using
RS-232 commands. Refer to RS-232 Error Codes on page 91 for more information.
Runco X-200i Series Installation/Operation Manual
Possible Cause(s)
• The Red/Pr, Green/Y or
Blue/Pb outputs from the
source are connected to
the wrong inputs on the
X-200i.
• The lamp has failed or
exceeded its usage life.
• The lamp cover is open.
• X-200i internal
temperature is too high.
• Fans are not working
properly or power-on
self-test has failed (Note).
• Rear-projection installation
uses second-surface
mirrors that are producing
faint, secondary
reflections.
• Incorrect L-R Swap
setting.
• Glasses are not charged
and/or communicating
with the Active3D Emitter.
Solution
• Ensure that the source
outputs are connected to
the correct X-200i input.
• Replace the lamp with a
new one.
• Close the lamp cover.
• Power off the X-200i and
allow it to cool down.
Ensure that the intake and
exhaust vents are not
blocked. Turn the
projector back on. If the
problem persists, please
contact Runco Technical
Support for assistance.
• Please contact Runco
Technical Support for
assistance.
• Always use first-surface
mirrors in your
rear-projection installation.
• Change the L-R Swap
setting (refer to L-R Swap
on page 58).
• Refer to Using the 3D
Glasses on page 73.
79
Maintenance and Troubleshooting