Service - Runco XtremeProjection X-200i Installation & Operation Manual

Operation
Infrared Remote: Select Infrared Remote from the Control menu to specify the remote
IR code set to which the X-200i responds. The default is Normal. Choose Code 2 if other
equipment in the theater responds to commands from the X-200i remote control in ways
that are unexpected or undesirable. Choose Code 2 to disable IR communication
altogether.
When you select a different remote code set on the X-200i, you must re-program the
remote control unit to use that same code set. To do this, press and hold the LIGHT and
ENTER buttons simultaneously for approximately five seconds. When the code set has
changed, the remote control back-lighting "blinks" to visually confirm the change.
Table 6-1 lists the IR codes associated with each remote control button.
HDMI CEC: This control chooses whether or not the X-200i responds to HDMI CEC
control messages from a disc player, set-top box or other HDMI source.
The default setting is On. For more information about CEC, refer to Using HDMI CEC
Messages on page 93.
Access the Service Menu, shown in Figure 4-11, to view information that indicates the

Service

projector's current operational status:
• Active Source
• Signal Format
• Pixel Clock
• Refresh Rate
• Lamp Hours (number of lamp hours elapsed since the last reset)
Should you ever need to contact Runco Technical Support, this information will help them
answer your questions and/or resolve product performance issues.
Figure 4-11. X-200i Service Menu
Runco X-200i Series Installation/Operation Manual 71