Runco XtremeProjection X-200i Installation & Operation Manual page 98

External Control
Key Commands: The syntax for key commands is simple:
ky <keyname>[CR]
Some key command examples:
ky menu[CR]
ky cur.up[CR]
The response from the projector for key commands is ACK: followed by the same
command in UPPERCASE.
Input: ky menu[CR]
Response: ACK:MENU [CR]
Table 6-1 lists the serial command key names and IR codes.
Table 6-1. Serial Command Key Names and IR Codes
RS232 Remote
Keyname Button
(none)
menu
enter
cur.down
cur.up
cur.left
cur.righ
(none)
(none)
(none)
IR Code
Set 1 Set 2
0x01 0xB7 Turn power on.
0x02 0xB8 Switch to the next source.
0x09 0xB9 Turn power off.
0x15 0xBA Bring up or cancel menu display.
0x17 0xBB Keypad enter.
0x18 0xBC Keypad down arrow.
0x1A 0xBD Keypad up arrow.
0x1D 0xBE Keypad left arrow.
0x1F 0xBF Keypad right arrow.
0x80 0xC0 Bring up or cancel brightness slider.
0x81 0xC1 Bring up or cancel contrast slider.
0x84 0xC4 Force reacquisition of active source.
0x85 0xC5 Switch to the next gamma.
0x86 0xC6 Switch to 2.5 gamma.
82 Runco X-200i Series Installation/Operation Manual
Bring up or cancel menu display.
Up arrow.
Description