Connecting The Active 3D Emitter To The Projector; Connecting To Ac Power; Active 3D Emitter Connection - Runco XtremeProjection X-200i Installation & Operation Manual

Connect the 3D SYNC IN port on the emitter to the 3D SYNC connector on the
projector, as shown in Figure 3-17.
Secure the emitter in the desired location using double-sided tape or
Tip
a similar adhesive material.
POWER POWER
POWER POWER
WIRED REMOTE WIRED REMOTE
REMOTE REMOTE WIRED WIRED
I I II II
12V TRIGGER 12V TRIGGER
TRIGGER TRIGGER 12V 12V
3D SYNC
SYNC 3D
Figure 3-17. Active 3D Emitter Connection
Projector: The X-200i ships with various types of AC power cords. Choose the one that
is appropriate to your locale.
Plug the female end of the power cord into the AC receptacle on the rear of the projector
(AC 100V ~ 240V); see Figure 2-2. Then, connect the other end to your AC power source.
AutoScope Lens Motor: With AutoScope-equipped projectors, an additional power
cord is provided for the lens motor. Plug the female end of the AC power cord into the AC
input on the rear of the lens motor assembly. Connect the other end to your AC power
source.
Runco X-200i Series Installation/Operation Manual
ISSUE ISSUE
ISSUE ISSUE
LED STA LED STATUS T T TUS A A
STATUS TUS A A STA T T LED LED
RS-232 RS-232 USB USB
USB USB
3D
SYNC IN
SOURCE SOURCE
SOURC SOURC
POWER POWER
POWER POWER
COMPONENT 1 COMPONENT 1
1 1 COMPONENT COMPONENT
35
Installation
Connecting the Active 3D
Emitter to the Projector

Connecting to AC Power