Quick Setup - Runco VideoXtreme VX-11d Installation & Operation Manual

Installation
3.2

Quick Setup

Table 3-1 gives a quick overview of the VX-11d installation process. The sections
following this one provide detailed instructions.
Table 3-1. Installation Overview
Step
Choose a location for the projector
1
Install CineWide lens mounting assembly (stationary base
2
plate or AutoScope lens motor – optional)
3 Mount the projector
Connect the DHD Controller to the projector
4
Connect signal sources to the DHD Controller
5
Connect other external equipment to DHD Controller
(optional):
• Audio processor or secondary display device
• Automation/control system (RS-232)
6
• 12-volt trigger-activated equipment (AutoScope lens
motor, retractable screens or screen masking etc.)
• External IR repeater
• Network hub, router or gateway (Ethernet)
Connect projector, DHD Controller and lens motor (if
7
present) to AC power and power up
Adjust primary lens: projected image size (zoom), position
8
(shift) and focus; copy and paste settings as needed
For rear-screen and/or ceiling-mount installations, select
9
the proper picture orientation
Use Image Alignment controls to fine-tune image geometry
10
Install and adjust CineWide anamorphic lens (optional)
11
Display calibration: adjust the following for each input and
display mode (resolution and frame rate); save settings
when finished:
• Aspect ratio
• Brightness
12
• Contrast
• Color level
• Tint
• Sharpness
• White Balance
Procedure
16 Runco VX-11d Installation/Operation Manual
For Details, Refer to
page...
17
24
28
29
30
36
39
20, 40
41
42
44
53