Runco VideoXtreme VX-11d Installation & Operation Manual page 90

Operation
Input Names
Restore
C o mp o s i t e 1 Composite 1
C o mp o s i t e 2
Composite 2
C o mp o s i t e 3
Composite 3
C o mp o n e n t
Component
H D 1
HD 1
H D 2
HD 2
S C A R T
SCART
H D M I 1 HDMI 1
H D M I 2
HDMI 2
H D M I 3
HDMI 3
H D M I 4
HDMI 4
Input Names: You can give each DHD Controller input a descriptive name. For example,
you may want to change the default input name to the type of source component
connected to it: "VCR," "DVD," "Laptop" et cetera. Input names can be up to 12
characters long.
To edit an input name, select Input Names from the Service menu. Press
an input and press ENTER. Use the
or to select a character to change. When you have finished editing the input name,
press ENTER or MENU.
To restore the default input name, press
"Restore" column. Then, press ENTER.
Display Device - Configure: The options in the Display Device - Configure menu allow
you to change the picture orientation, perform lens adjustments or access other,
display-device specific functions.
• Installation – Orientation: Select Installation from the Display Device - Configure
menu, then select Orientation to change the picture orientation to suit the method of
installation (Floor Front, Floor Rear, Ceiling Front or Ceiling Rear). Or, for
front-projection installations, use the Auto setting to have the projector automatically
determine the orientation (floor or ceiling) using an internal sensor.
• Lens: Select Lens from the Display Device - Configure menu to access the motorized
lens controls. Refer to Primary Lens Adjustments on page 40.
• Display Info.: Select Display Info. from the Display Device - Configure menu to see the
projector serial number and lamp usage information (number of hours in service).
• Lamp Hours Reset: When you replace the projector lamp (refer to Lamp
Replacement on page 83), you should also reset the lamp hour counter to zero so
that the lamp usage information in the Display Info. window is accurate. To do this,
select Lamp Hours Reset from the Display Device - Configure menu. A confirmation
dialog box appears. Select "Yes" to continue with the reset or "No" to cancel the
operation.
• Diagnostics: Select Diagnostics from the Display Device - Configure menu, then
select Red, Green, Blue, Yellow, Cyan or Magenta to display only that color channel
(simulating a filter of that color). This can be useful for calibration or measurement
purposes.
To restore the normal picture (all colors), select White.
• Altitude: Select Altitude from the Display Device - Configure menu to control the
operation of the projector's cooling fan.
In most cases, the default setting (Auto) will maintain the correct operating
temperature. If the lamp frequently turns off due to overheating, or in certain
high-altitude operating environments, you may need to change this setting to High.
or buttons to change a character; press
repeatedly to highlight that input name in the
74 Runco VX-11d Installation/Operation Manual
or to select