Turning On The Power; Primary Lens Adjustments; Focus; Zoom - Runco VideoXtreme VX-11d Installation & Operation Manual

Installation
3.7

Turning on the Power

3.8
Primary Lens
Adjustments

Focus

Zoom

Vertical and Horizontal
Lens Shift
1. Turn on your source components.
2. If this is an AutoScope-equipped projector, turn on the main power switch at the rear
of the AutoScope lens motor. The lens motor power switch is located next to the AC
input (see Figure 3-19).
3. Turn on the main power switch at the rear of the DHD Controller.
4. Press the ON button on the remote control (or the ON/STANDBY (
DHD Controller front panel) to turn on the system. The vacuum fluorescent display on
the DHD Controller front panel briefly displays "Initializing System," followed by
"Starting VX-11d."
5. When the projector is ready for use, the fluorescent display indicates the active
source, input resolution/frame rate and aspect ratio; for example:
VX-11d
16:9
Aspect Ratio
To access the motorized lens controls:
1. On the DHD Controller remote control or front panel, press MENU.
2. Select Service from the Main Menu and enter the Service Menu passcode.
You must enter a passcode to access the Service menu.
Note
3. Select Display Device from the Service Menu.
4. Select Configure from the Display Device menu, then select Lens.
The Lens menu gives you a great deal of control over the picture size, position and focus:
To focus the projected image, use the cursor buttons to highlight "In" or "Out." Then,
press and hold the ENTER button.
To make the picture smaller (zoom out), use the cursor buttons to highlight the minus sign
(-). Then, press and hold the ENTER button.
To enlarge the picture (zoom in), use the cursor buttons to highlight the plus sign (+).
Then, press and hold the ENTER button.
To change the lens position, use the cursor buttons to highlight "Left," "Right," "Up" or
"Down" in the Lens menu. Then, press and hold the ENTER button to shift the lens in that
direction.
Current
Source
HDMI 1
1080i/60
Input Resolution/Frame Rate
40 Runco VX-11d Installation/Operation Manual
) button on