Runco VideoXtreme VX-11d Installation & Operation Manual page 92

Operation
If you prefer to do this manually, set it to Off. The DHD Controller will ask if you want
to perform the upgrade the next time it is power-cycled.
• Check For New Firmware: To have the DHD Controller check for new firmware on
demand (and perform an upgrade if it finds a new version), select Check For New
Firmware from the Auto Firmware Upgrade menu. If the DHD Controller finds a new
firmware version, select Yes to perform the upgrade or No to return to the previous
menu.
• E-Mail Notification: Select E-Mail Notification from the Network menu to specify
when and to whom the DHD Controller sends error and service notification messages
via e-mail.
The notification messages are in the following format:
To: [E-Mail Address; see below]
From: do-not-reply@runco.com
Subject: [Type of notification] from Runco DHD4
Body:
This is an automated message sent from the Runco DHD4:
Notification:
Detailed Description: [ If a DHD Error, one of the following:
Serial Number:
Customer Information: [From "Customer Information" sub-menu;
Best Regards,
Runco International, LLC
1195 NW Compton Drive
Beaverton, OR 97006
1-800-237-8262
• E-Mail Address: To specify the destination e-mail address for error and service
notifications, select E-Mail Address from the E-Mail Notification menu. The
procedure is similar to that for setting the IP address (refer to IP Configuration on
page 75). Enter up to 45 alphnumeric characters.
[One of the following:
"DHD Error" / "Display Error"
"Periodic Service Notification"
"Lamp Life Notification" / "Calibration Data"]
"Fan Failure 1" / "Fan Failure 2"
"Overtemp 1" / "Overtemp 2"
"Initialization Failure"
If a Display Error, a device-specific
error message such as "Lamp Door Open"
If a Periodic Service Notification, the elapsed
time since the last notification
If a Lamp Life Notification, the number of hours
the lamp has been in service
If a Calibration Data message,
"See Attached File" ]
[DHD Controller serial number]
see below]
76 Runco VX-11d Installation/Operation Manual