Adjusting The Picture Orientation - Runco VideoXtreme VX-11d Installation & Operation Manual

To return the lens to its home position (no horizontal or vertical shift), use the cursor
buttons to highlight "Home" in the Lens menu. Then, press the ENTER button.
You should copy and paste the lens position settings to all aspect
Note
ratios and screens that will be used. Otherwise, the lens will go the
home position when the aspect ratio or screen selection changes. For
more information, refer to Copy/Paste - Aspect Ratio on page 71.
By default, the VX-11d is configured for a "floor/front" installation, in which the projector is
installed upright and in front of the screen. If it is installed behind the screen and/or
mounted on a ceiling, you must change the picture orientation. To do this:
1. On the DHD Controller remote control or front panel, press MENU.
2. Select Service from the Main Menu and enter the Service Menu passcode.
You must enter a passcode to access the Service menu.
Note
3. Select Display Device from the Service Menu.
4. Select Configure from the Display Device menu, then select Installation.
5. Select Orientation, then choose Floor/Rear, Ceiling/Front or Ceiling/Rear, to match
the installation method.
Runco VX-11d Installation/Operation Manual 41
Installation
3.9
Adjusting the Picture
Orientation