Runco VideoXtreme VX-11d Installation & Operation Manual page 41

Installation
Remove Projector Front Feet: Place the projector upside down on a blanket or other
soft surface. Loosen and remove the two front feet on the projector.
Install Ceiling Mount Adapters/Projector Stands: For ceiling installations, the
adapters bring the attachment points for the projector mounting rails (included with the
projector ceiling mount kit) from the bottom of the projector up and around the AutoScope
lens motor housing. For floor installations (where the projector is upright), the adapters
allow the projector to lie flat on the mounting surface.
Using eight (8) each of the supplied, Pan-Head Phillips screws, attach the AutoScope
Ceiling Mount Adapters/Projector Stands to the projector as shown in Figure 3-7.
Figure 3-7. Installing the Ceiling Mount Adapters/Projector Stands
DO NOT OVER-TIGHTEN THE SCREWS.
Caution
Runco VX-11d Installation/Operation Manual 25