11Wan Interface Setup; I Static Ip - Rosewill RNX-G40 User Manual

Wireless Router RNX-G40
Item
IP Address
Subnet Mask
Default Gateway
DHCP Server
DHCP Client Range
Show Client
802.Id Spanning Tree
Clone MAC Address
Apply Changes
Reset
3.3.11 WAN Interface Setup
This page is used to configure the parameters for wide area network that connects to the WAN port of your
WLAN AP Router. Here you may change the access method to Static IP, DHCP, PPPoE or PPTP by click the
item value of WAN Access Type.
I Static IP
Screen snapshot - WAN Interface Setup - Static IP
Description
Fill in the IP address of LAN interfaces of this WLAN AP Router.
Fill in the subnet mask of LAN interfaces of this WLAN AI Router.
Fill in the default gateway for LAN interfaces out going data packets.
Click to select Disabled, Client or Server in different operation mode of wireless AP
router.
Fill in the start IP address and end IP address to allocate a range of IP addresses;
client with DHCP function set will be assigned an IP address from the range.
Click to open the Active DHCP Client Table window that shows the active clients
with their assigned IP address, MAC address and time expired information. [Server
mode only]
Select to enable or disable the IEEE 802.Id Spanning Tree function from pull-down
menu.
Fill in the MAC address that is the MAC address to be cloned. Refer to 4.24 What
is Clone MAC Address?
Click the Apply Changes button to complete the new configuration setting.
Click the Reset button to abort change and recover the previous configuration
setting.
- 30 -
User Manual