Table of Contents
Advertisement
Wireless Router
RNX-G40
3
Software configuration
The web based management and configuration functions allow you to do the step-by-step easily.
The WLAN AP Router is delivered with the following factory default parameters on the Ethernet LAN
interfaces. For the first time setting, you need to use the computer which connects to the LAN port of the
router to complete the first setting Directly by RJ45 cable.
Default IP Address:
Default IP subnet mask:
WEB login User Name:
WEB login Password:
3.1 Prepare your PC to configure the WLAN AP Router
For Microsoft Windows 95/ 98/ ME:
1.
Click the Start button and select Settings, then click Control Panel. The Control Panel window will
appear.
Note: Windows Me users may not see the Network control panel. If so, select View all Control Panel
options on the left side of the window
2.
Move mouse and double-click the right button on Network icon. The Network window will appear.
3.
Check the installed list of Network Components. If TCP/IP is not installed, click the Add button to
install it; otherwise go to step 6.
4.
Select Protocol in the Network Component Type dialog box and click Add button.
5.
Select TCP/IP in Microsoft of Select Network Protocol dialog box then click OK button to install the
TCP/IP protocol, it may need the Microsoft Windows CD to complete the installation. Close and go
back to Network dialog box after the TCP/IP installation.
6.
Select TCP/IP and click the properties button on the Network dialog box.
7.
Select Specify an IP address and type in values as following example.
IP Address: 192.168.1.1, IP address within the range of 192.168.1.1 to 192.168.1.253 is used to
connect the WLAN AP Router.
IP Subnet Mask: 255.255.255.0
8.
Click OK and reboot your PC after completing the IP parameters setting.
192.168.1.254
255.255.255.0
user
user
- 11 -
User Manual
Advertisement
Table of Contents
