Hitachi SJ2002 Series Instruction Manual page 137

Analog Signal Calibration Settings
The functions in the following table configure the signals for the analog output termi-
nals. Note that these settings do not change the current/voltage or sink/source character-
istics—only the zero and span (scaling) of the signals.
Func. Name /
Code SRW Display
C081 O input span calibration Scale factor between the
O-ADJ 0100.0%
C082 OI input span calibra-
tion
OI-ADJ 0100.0%
C085 Thermistor input tuning Range is 0.0 to 200.0%
PTC Adj 0100.0%
C086 [AM] terminal offset
tuning
AM-OFFST 0000.0V
NOTE: When you restore factory default settings, the values will change to those listed
above. Be sure to manually reconfigure the values for your application, if needed, after
restoring factory defaults.
"C" Function
Description
external frequency command
on terminals L – O (voltage
input) and the frequency
output, range is 0.0 to 200.0%
Scale factor between the
external frequency command
on terminals L – OI (current
input) and the frequency
output, range is 0.0 to 200.0%
Range is 0.0 to 10.0V
SJ200 Inverter
2
Run Defaults
Mode
–FE(F) –FU
Edit
(EU) (USA)
Lo Hi
✔ ✔
100.0 100.0
✔ ✔
100.0 100.0
✔ ✔
100.0 100.0
✔ ✔
0.0 0.0
3–57
Units
%
%
%
V