Hitachi SJ2002 Series Instruction Manual page 133

Output Function Summary Table – This table shows all eleven functions for the
logical outputs (terminals [11], [12]) at a glance. Detailed descriptions of these
functions, related parameters and settings, and example wiring diagrams are in
Intelligent Output Terminals" on page
Option Terminal
Function Name
Code Symbol
00 RUN Run Signal
01 FA1 Frequency Arrival
Type 1 – Constant
Speed
02 FA2 Frequency Arrival
Type 2 – Over-
frequency
03 OL Overload Advance
Notice Signal
04 OD Output Deviation for
PID Control
05 AL Alarm Signal
06 Dc Analog Input
Disconnect Detect
07 FBV PID Second Stage
Output
08 NDc ModBus Network
Detection Signal
4–36.
Output Function Summary Table
ON when inverter is in Run Mode
OFF when inverter is in Stop Mode
ON when output to motor is at the set frequency
OFF when output to motor is OFF, or in any accelera-
tion or deceleration ramp
ON when output to motor is at or above the FA2
threshold (C042) during accel
OFF when output to motor is below the FA2 threshold
(C043) during decel
ON when output current is more than the set thresh-
old for the overload signal
OFF when output current is less than the set threshold
for the overload signal
ON when PID error is more than the set threshold for
the deviation signal
OFF when PID error is less than the set threshold for
the deviation signal
ON when an alarm signal has occurred and has not
been cleared
OFF when no alarm has occurred since the last
clearing of alarm(s)
ON when the [O] input value < B082 setting (signal
loss detected), or the [OI] input current < 4mA
OFF when no signal loss is detected
ON Transitions to ON when the inverter is in RUN
Mode and the PID Process Variable (PV) is less
than the Feedback Low Limit (C053)
OFF Transitions to OFF the PID Feedback Value (PV)
exceeds the PID High Limit (C052), and transi-
tions to OFF when the inverter goes from Run
Mode to Stop Mode.
ON when the communications watchdog timer
(period specified by C077) has timed out
OFF when the communications watchdog timer is
satisfied by regular communications activity
SJ200 Inverter
2
Description
3–53
"Using