Hitachi SJ2002 Series Instruction Manual page 129

Option Terminal
Function Name
Code Symbol
12 EXT External Trip
13 USP Unattended Start
Protection
15 SFT Software Lock
16 AT Analog Input
Voltage/current
Select
18 RS Reset Inverter
19 PTC PTC Thermistor
Thermal Protection
20 STA Start
(3-wire interface)
21 STP Stop
(3-wire interface)
22 F/R FWD, REV
(3-wire interface)
Input Function Summary Table
ON When assigned input transitions OFF to ON,
inverter latches trip event and displays E12
OFF No trip event for ON to OFF, any recorded trip
events remain in history until Reset
ON On powerup, the inverter will not resume a Run
command (mostly used in the US)
OFF On powerup, the inverter will resume a Run
command that was active before power loss
ON The keypad and remote programming devices
are prevented from changing parameters
OFF The parameters may be edited and stored
ON Terminal [OI] is enabled for current input (uses
terminal [L] for power supply return)
OFF Terminal [O] is enabled for voltage input (uses
terminal [L] for power supply return)
ON The trip condition is reset, the motor output is
turned OFF, and powerup reset is asserted
OFF Normal power-ON operation
ANLG When a thermistor is connected to terminals [5]
and [L], the inverter checks for over-
temperature and will cause trip event and turn
OFF output to motor
OPEN A disconnect of the thermistor causes a trip
event, and the inverter turns OFF the motor
ON Starts the motor rotation
OFF No change to present motor status
ON Stops the motor rotation
OFF No change to present motor status
ON Selects the direction of motor rotation: ON =
FWD. While the motor is rotating, a change of
F/R will start a deceleration, followed by a
change in direction.
OFF Selects the direction of motor rotation: OFF =
REV. While the motor is rotating, a change of F/
R will start a deceleration, followed by a change
in direction.
SJ200 Inverter
2
Description
3–49