Displaying The Log - Hitachi CP-X8150 User Manual

Status Monitor <Only for CP-X8160, CP-WX8250 and CP-WU8450>

Displaying the log

The present setup information and the error history can be displayed on the
Status Monitor with button operation.
• While the projector is warming up, button presses are ignored.
NOTE
• When the USB TYPE A port is selected, use the buttons on the control panel
to display the logs. The button operation of the Status Monitor on the remote
control may be unavailable.
• The Status Monitor displays nothing or no button presses for the monitor are
available while the projector is in standby mode if the STANDBY MODE item of
SETUP menu is set to SAVING (
• Both of the Status Monitor and the OSD menu cannot be operated at same time.
When the projector is in a normal condition,
or dislays one of the warnings of AIR FLOW,
COLD or FILTER errors, press the FUNCTION
button on the control panel or press the ENTER
button on the remote control for three seconds.
The backlight of the monitor turns on.
To display the setup information including
usage time
Use the ◄/► buttons to switch display.
First display
Usage time: The Status Monitor displays
the lamp time (usage time of the present
lamp), the lter time (usage time of the air
lter) and the projector usage time.
Network information: The network information is displayed over three pages.
Use the ▲/▼ buttons to switch the page.
Displayed information in each page is as below;
2nd page
1st page
3rd page
(continued on next page)
22
Usage time
: Subnet mask
(wireless and wired)
: IP address
(wireless and wired)
: Default gateway
(wireless and wired)
54).
Network
information
0
F I L T E R 1 2 8 3 5 h
S Y S T E M 2 2 3 8 6 h
Usage time (example)
I P A D D R E S S
W 1 9 2 1 6 8 0 0
N 1 9 2 1 6 8 0 0 1 0 7 5
Network information
FUNCTION
button
Lamp time
L A M P 2 2 5 0 h
Filter time
Projector
usage time
Wireless
2 1 9 6
Wired
(example)
ENTER
button