3.1 Projector Web Control - Date/Time Settings (continued)
Item
Time difference
SNTP
SNTP Server Address
Cycle
Click the [Apply] button to save the settings.
• The new conguration settings are activated after restarting the
NOTE
network connection. When the conguration settings are changed, you must
restart the network connection. You can restart the network connection from
Network Restart on the main menu(
• If you connect the projector to an existing network, consult a network
administrator before setting server addresses.
• Once you turn off the projector in the SAVING mode (
Operating Guide) or the AC power, the current date and time setting is reset.
• To enable the SNTP function, the time difference must be set.
• The projector will retrieve Date and Time information from the time server and
override time settings when SNTP is enabled.
• The internal clock's time may not remain accurate. Using SNTP is
recommended to maintain accurate time.
Congures the time difference. Set the same time difference
as the one set on your computer. If unsure, consult your IT
manager.
Click the [ON] check box to retrieve Date and Time
information from the SNTP server and set the following items.
Congures the SNTP server address in IP format.
• The address allows not only IP address but also domain
name if the valid DNS server is setup in the Network
Settings. The maximum length of host or domain name is up
to 255 characters.
Congures the interval at which to retrieve Date and Time
information from the SNTP server (hour:minute).
41).
3. Web Control
SETUP menu in the
31