Hitachi CP-X8150 User Manual page 155

3. Web Control
3.1 Projector Web Control - Network Settings (continued)
Item
Wireless Setup
Mode
IP Address
Subnet Mask
Gateway
Ch
Encryption
WEP Key
WPA Passphrase
(continued on next page)
20
Congures the wireless LAN settings.
Select "Ad-Hoc" or "Infrastructure".
Congures network settings.
Enables DHCP.
Disables DHCP.
Congures the IP address when DHCP is disabled.
Congures the subnet mask when DHCP is disabled.
Congures the default gateway when DHCP is disabled.
Congures the DNS server address.
Select from "1" to "11" a channel to use in the Ad-Hoc mode.
• Depending on the country where you are
NOTE
the channels may vary. In addition, depending on the
country or region where you are may be required to use a
wireless network card that conrm to the standards in the
respective country or region.
Select data encryption method.
Input the WEP key.
Either ASCII characters or hexadecimal numbers can be
used during WEP key input. However, you cannot use a
combination of both.The length of the key is dened as
follows according to the WEP and character formats.
Encryption
WEP 64bit
WEP 128bit
Input WPA Passphrase.
Available number of input characters is 8 to 63. Only
alphabets, numbers and following symbols can be used.
!"#$%&'()*+,-./:;<=>?@ [\]^_`{|}~ and space
Select an SSID from the list.
If you require to set your unique SSID, select [Custom], then
set your own SSID following the rules below.
Maximum number of input characters is 32.
Only alphabets, numbers and following symbols can be used.
!"#$%&'()*+,-./:;<=>?@[\]^_`{|}~ and space.
ASCII characters
5 characters
13 characters
HEX numbers
10 characters
26 characters