Connecting To A Power Supply - Hitachi CP-X8150 User Manual

Setting up

Connecting to a power supply

1.
Put the connector of the power cord into the
AC IN (AC inlet) of the projector.
2.
Firmly plug the power cord's plug into the
outlet. In a couple of seconds after the power
supply connection, the POWER indicator will
light up in steady orange.
Please remember that when the DIRECT POWER ON
function activated (
supply make the projector turn on.
WARNING
unit is attached to it.
►Please use extra caution when connecting the power cord, as incorrect or
faulty connections may result in  re and/or electrical shock.
• Do not touch the power cord with a wet hand.
• Only use the power cord that came with the projector. If it is damaged, consult
your dealer to get a new one. Never modify the power cord.
• Only plug the power cord into an outlet whose voltage is matched to the power
cord. The power outlet should be close to the projector and easily accessible.
Remove the power cord for complete separation.
• Do not distribute the power supply to multiple devices. Doing so may overload
the outlet and connectors, loosen the connection, or result in  re, electric shock
or other accidents.
• Connect the ground terminal for the AC inlet of this unit to the ground terminal
of the building using an appropriate power cord (bundled).
• This product is also designed for IT power systems with a phase-
NOTICE
tophase voltage of 220 to 240 V.
16
64), the connection of the power
►Do not connect the projector to a power supply while no lens
AC IN
Power
cord