Test Run - Shop fox W1674 Owner's Manual

Test Run

Complete this process once you have familiarized yourself
with all instructions in this manual.
To test run the shaper, do these steps:
1. Read the entire instruction manual first!
2. Make sure all tools and foreign objects have been
removed from the machine.
3. Make sure the spindle switch is in the STOP (center)
position.
4. Review Page 9 and connect your machine to the
power source.
5. Turn the shaper ON by moving the spindle switch to
either the forward (FOR) or reverse (REV) position.
— The shaper should run smoothly with little or no
vibration.
— Immediately turn the shaper OFF if you suspect
any problems, and refer to Page 50 to trouble-
shoot/fix any problems before starting the shaper
again.
— If the source of an unusual noise or vibration is not
readily apparent, contact our technical support
for help at (360) 734-3482 or contact us online at
tech-support@shopfox.biz.
6. Move the spindle switch to the STOP position, wait
for the spindle to come to a complete stop, then
repeat Step 5 for the opposite direction.
7. Turn the spindle ON and OFF in the same direction
and notice the direction it is turning.
Note: When the spindle switch is in the forward
position, the spindle should turn counterclockwise
as viewed from above. The opposite is true when
the switch in the reverse position.
— If the spindle rotation direction and the position of
the spindle switch before you turned the machine
OFF do not match, disconnect the machine from
power, then switch wires #5 and #6 inside the
motor wiring junction box (refer to the Wiring
Diagram on Page 49 for specific information).
W1674 Owner's Manual (Mfg. After 9/05)
Projectiles thrown from the machine
could cause serious eye injury. Wear
safety glasses to reduce the risk of
injury.
Loose hair and clothing could get
caught in machinery and cause serious
personal injury. Keep loose clothing
rolled up and long hair tied up and
away from machinery.
-18-