Fence Assembly - Shop fox W1674 Owner's Manual

W1674 Owner's Manual (Mfg. After 9/05)
Spindle Height Handwheel
1. Thread the handle into the hole provided on the
handwheel, then fully tighten it (see Figure 10).
2. Align the set screw in the handwheel hub with the
shaft flat, then slide the handwheel onto the shaft
and tighten the set screw.
Spindle Switch
1. Remove the motor cover.
2. Use the handwheel to raise the spindle and motor to
its highest position.
3. Reach inside the cabinet and pull the spindle switch
out from underneath the motor.
4. Use the two pre-installed screws to mount the
spindle switch, as shown in Figure 11.
5. Re-install the motor cover.
6. Attach the spindle switch cord grommet to the
motor cover, as shown in Figure 12.

Fence Assembly

The fence assembly supports the fence boards and the
safety guard. The position of the fence assembly, the
fence boards, and the safety guard are all independently
adjustable.
Note: Refer to the Fence Adjustment subsection on Page
24 for detailed operating instructions.
To install the fence assembly, do these steps:
1. Remove the two hex bolts, three cap screws, lock
washers, and flat washers from the back of the table
top (see Figure 13).
Note: The two hex bolts and lock washers are used
when installing the safety guard without the fence
assembly.
Figure 10. Spindle height handwheel
Figure 11. Spindle switch installed.
Figure 12. Installing switch cord grommet.
Hex Bolts
Figure 13. Fence and safety guard
mounting fasteners.
-15-
installed.
Cap Screws