Shop fox W1674 Owner's Manual page 31

W1674 Owner's Manual (Mfg. After 9/05)
Tools Needed
Spindle Wrench Set .............................................1
To install a cutter, do these steps:
1. DISCONNECT SHAPER FROM POWER!
Note: For convenience, remove the fence assembly
before performing the following steps.
2. Remove the two spindle nuts from the spindle.
3. Place the required spindle spacers on the insert, as
shown in Figure 39.
4. Protecting your hands from the sharp edges, slide a
spindle washer and then the cutter onto the spindle,
making sure the cutting edges are facing in the right
direction for your selected rotation (see Figure 40).
5. Place the remaining spindle washer onto the spindle,
then additional spacers as necessary, as shown in
Figure 41.
Qty
Spacer
Figure 39. Installing a spindle spacer.
Cutter
Figure 40. Placing a cutter onto the
Figure 41. Placing the remaining spindle
washer and spacer(s) onto the spindle.
-29-
spindle.
Spindle
Washer