Safety Guard - Shop fox W1674 Owner's Manual

W1674 Owner's Manual (Mfg. After 9/05)

Safety Guard

The safety guard on the Model W1674 is installed with or
without the fence assembly, and accepts an adjustable
front guard for additional protection from accidental
cutter contact during operation.
Safety Guard on Fence Assembly
When the safety guard is mounted on the fence assembly,
adjust its position by moving the entire fence assembly
(refer to Fence Adjustment on Page 24 for detailed
instructions) or by using the T-lock handle to position the
guard independently of the fence assembly.
Tools Needed
Phillips Screwdriver #2 .........................................1
To install the safety guard on the fence assembly, do
these steps:
1. DISCONNECT SHAPER FROM POWER!
2. Thread and hand-tighten the guard support into the
threaded hole on top of the fence assembly (see
Figure 44).
3. From underneath the safety guard, insert two
x ⁄ " flat head screws into the holes that are in the
5
8
center of the guard, then secure the shorter guard
mounting bar to the safety guard with two
hex nuts, as shown in Figure 44.
4. Secure the safety guard assembly to the guard
support with the T-lock handle, and secure the front
guard to the safety guard with two knob bolts.
To avoid the risk of severe injury or
amputation, ALWAYS properly install
the safety guard onto the shaper before
connecting the machine to power.
Qty
T-Lock Handle
Guard Support
⁄ "-20
1
4
Figure 44. Safety guard installed on the
⁄ "-20
1
4
-31-
Safety Guard
Guard Mounting
Bar (Short)
fence assembly.