W1674 Owner's Manual (Mfg. After 9/05)
Unpacking
This machine has been carefully packaged for safe
transportation. If you notice the machine has been
damaged during shipping, please contact your authorized
Shop Fox dealer immediately.
Inventory
The following is a description of the main components
shipped with the Model W1674. Lay the components out
to inventory them.
Note: If you can't find an item on this list, check the
mounting location on the machine or examine the
packaging materials carefully. Occasionally we pre-install
certain components for safer shipping.
Box 1 Inventory (Not Shown)
A. Shaper Unit .................................................1
B. Spindle Switch w/Padlock & Keys (inside cabinet) ..1
Box 2 Inventory (Figure 4)
C. Fence Assembly ............................................1
D. Fence Boards ...............................................2
E. Hardware Bag:
— Flat Hd Screws
⁄
1
— Flat Washers
⁄
" (Hold-Down Brackets) .............4
1
4
— Set Screws
⁄
"-20 x
1
4
— Cap Screws
⁄
"-20 x
1
4
— T-Nuts
⁄
"-20 (Fence Boards & Hold-Downs) .......8
1
4
— Hold-Down Bar Brackets ...............................2
— Hex Wrench 3mm .......................................1
SETUP
"-20 x
⁄
" (Fence Boards) ........4
3
4
4
⁄
" (Hold-Downs) ...............2
3
8
⁄
" (Hold-Down Brackets) ....4
1
2
Keep machine disconnected from
power until instructed otherwise.
Qty
Qty
E
Figure 4. Model W1674 inventory—box 2.
-11-
C
D