Test Run - Shop fox W1668 Owner's Manual

Test.Run
Once assembly is complete, test run the
machine to ensure it is properly connected to
power and safety components are functioning
properly.
If you find an unusual problem during the test
run, immediately stop the machine, disconnect it
from power, and fix the problem BEFORE oper-
ating the machine again. The Troubleshooting
table in the SERVICE section of this manual can
help.
To.test.run.the.machine,.do.these.steps:
1. Clear all setup tools away from machine.
2. Connect machine to power supply.
3. Turn machine ON, verify motor operation,
then turn machine OFF.
The motor should run smoothly and without
unusual noises.
4. Remove switch disabling key (see example).
5. Try to start machine with paddle switch.
The machine should not start.
— If machine does not start, the switch dis-
abling feature is working as designed.
— If machine does start, immediately stop
the machine. The switch disabling fea-
ture is not working correctly. This safety
feature must work properly before pro-
ceeding with regular operations. Call
Tech Support for help.
Model W1668/W1848 (Mfd. Since 08/16)
Serious.injury.or.death.can.result.from.using.
this.machine.BEFORE.understanding.its.con-
trols.and.related.safety.information..DO.NOT.
operate,.or.allow.others.to.operate,.machine.
until.the.information.is.understood.
DO. NOT. start. machine. until. all. preceding.
setup. instructions. have. been. performed..
Operating. an. improperly. set. up. machine.
may. result. in. malfunction. or. unexpected.
results. that. can. lead. to. serious. injury,.
death,.or.machine/property.damage..
Figure.25. Removing switch key from paddle
-24-
switch.