Table of Contents
Advertisement
Model W1741W/W1741SW (Mfd. Since 10/15)
Test.Run
Once assembly is complete, test run the machine to
ensure it is properly connected to power and safety
components are functioning properly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from power,
and fix the problem BEFORE operating the machine again.
The Troubleshooting table in the SERVICE section of this
manual can help.
To test run machine, do these steps:
1. Clear all setup tools away from machine.
2. Push STOP button in (see Figure.33).
3. Connect machine to power supply.
4. Twist STOP button clockwise until it pops out (see
Figure.34). This resets switch so machine will start.
5. Push START button to start machine. A correctly
operating machine runs smoothly with little or no
vibration or rubbing noises.
6. Press STOP button to turn machine OFF.
7. WITHOUT resetting STOP button, press START button.
Machine should not start.
— If machine does not start, the STOP button safety
feature is working correctly. Congratulations! The
Test Run is complete.
— If machine does start (with STOP button pushed
in), immediately disconnect power to machine.
The STOP button safety feature is not working
correctly. This safety feature must work properly
before proceeding with regular operations. Call
Tech Support for help.
Serious. injury. or. death. can. result.
from. using. this. machine. BEFORE.
understanding. its. controls. and. related.
safety.information..DO.NOT.operate,.or.
allow.others.to.operate,.machine.until.
the.information.is.understood..
DO. NOT. start. machine. until. all.
preceding.setup.instructions.have.been.
performed..Operating.an.improperly.set.
up. machine. may. result. in. malfunction.
or. unexpected. results. that. can. lead.
to. serious. injury,. death,. or. machine/
property.damage.
STOP
Button
Figure.33. STOP/START button locations.
STOP Button
Figure.34. Resetting the switch.
-25-
START
Button
Advertisement
Table of Contents
