Service; General; Table Insert Adjustment - Shop fox W1674 Owner's Manual

General

This section covers the most common service adjustments
or procedures that may need to be made during the life
of your machine.
If you require additional machine service not included
in this section, please contact Woodstock International
Technical Support at (360) 734-3482 or send e-mail to:
tech-support@shopfox.biz.

Table Insert Adjustment

The aluminum table insert is held in place by a cast
iron insert ring, which should be adjusted level with the
table top (see Figure 63). This is necessary to avoid the
workpiece catching on the insert or ring during operation,
causing an unsafe condition and poor cutting results.
Tools Needed
Phillips Screwdriver #2 .........................................1
Standard Screwdriver #2 .......................................1
Precision Straightedge .........................................1
To make the insert and insert ring level with the table
top, do these steps:
1. DISCONNECT SHAPER FROM POWER!
2. Remove the table insert, then remove the three
Phillips screws that secure the insert ring to the
table top.
Note: Notice that there is a barrel screw underneath
each of the Phillips screws (see Figure 64).
3. Lay a precision straightedge across the insert ring
and the table, then adjust the barrel screws until
the insert ring is level with the table top in all
directions.
4. Replace the Phillips screws, but do not overtighten
them.
5. Replace the table insert, then use the straightedge
to re-check the inserts. If necessary, repeat this
procedure until both the insert ring and table
insert are completely level with the table top in all
directions.
W1674 Owner's Manual (Mfg. After 9/05)

SERVICE

MAKE SURE that your machine is
unplugged during all service proce-
dures! If this warning is ignored, seri-
ous personal injury may occur.
Qty
Insert
-44-
Ring
Figure 63. Leveling the insert ring.
Figure 64. Insert ring barrel screw.
Table
Insert