Call Hold; Call Waiting; Call Transfer; Blind Transfer - Grandstream Networks GXW-4004 User Manual

Note: NO dial tone will be played between step 1 and 2.
Destination ports can be specified by using "*" (encoding for ":") followed by the port number.
Examples:
a) If the target IP address is 192.168.0.160, the dialing convention is
*47 or Voice Prompt with option 47, then 192*168*0*160.
followed by pressing the "#" key if it is configured as a send key or wait 4 seconds. In this case,
the default destination port 5060 is used if no port is specified.
b) If the target IP address/port is 192.168.1.20:5062, then the dialing convention would be:
*47 or Voice Prompt with option 47, then 192*168*0*160*5062 followed by pressing the "#" key
if it is configured as a send key or wait for 4 seconds.
NOTE: When completing direct IP call, the "Use Random Port" should set to "NO". You can not make
direct IP calls between FXS ports since they are using same IP.

CALL HOLD

Place a call on hold by pressing the "flash" button on the analog phone (if the phone has that button).
Press the "flash" button again to release the previously held Caller and resume conversation. If no "flash"
button is available, use "hook flash" (toggle on-off hook quickly). You may drop a call using hook flash.

CALL WAITING

Call waiting tone (2 short beeps) indicates an incoming call, if the call waiting feature is enabled. Toggle
between incoming call and current call by pressing the "flash" button. First call is placed on hold. Press
the "flash" button to toggle between two active calls.

CALL TRANSFER

BLIND TRANSFER

Assume that call Caller A and B are in conversation. A wants to Blind Transfer B to C:
3. Caller A presses FLASH on the analog phone to hear the dial tone.
4. Caller A dials *87 then dials caller C's number, and then # (or wait for 4 seconds).
FIRMWARE VERSION 1.0.9.1 GXW40XX USER MANUAL Page 21 of 60