Grandstream Networks GXW-4004 User Manual page 39

Analog ip gateway gxw40 series 4, 8 or 24 fxs ports
Hide thumbs Also See for GXW-4004:
Table of Contents

Advertisement

ACS Password
Periodic Inform Enable
Periodic Inform Interval
Connection Request
Username
Connection Request
Password
Connection Request Port
CPE SSL Certificate
CPE SSL Private Key
System Ring Cadence
Call Progress Tones
Prompt Tone Access Code
Lock Keypad Update
Disable Voice Prompt
Disable Direct IP Call
FIRMWARE VERSION 1.0.9.1
User specify the ACS password
Default is No. If set to YES, device will send inform packets to the ACS
Frequency that the inform packets will be sent out to the ACS
Set a user name for the ACS to connect to this device
Set a password for the ACS to connect to this device
Set a port number for the ACS to connect to this device, default is 7547
Configure the SSL authentication of Customer-premises equipment
Configure the SSL Private Key of Customer-premises equipment
Configuration option for all FXS ports ring cadence for all incoming calls.
(Syntax: c=on1/off1-on2/off2-on3/off3; [...]) Default is set to c=2000/4000; (US
standards)
Using these settings, user can configure tone frequencies according to user
preference. By default, the tones are set to North American frequencies.
Frequencies should be configured with known values to avoid uncomfortable high
pitch sounds. ONis the period of ringing (ON time in ms) while OFF is the period of
silence. In order to set a continuous ring, OFF should be zero. Otherwise it will ring
ON ms and a pause of OFF ms and then repeat the pattern.
• "Dial tone"
• "Ringback tone"
• "Busy/Re-order tone"
• "Confirmation tone"
Please refer the document below to determine your local call progress tones:
http://www.itu.int/ITU-T/inr/forms/files/tones-0203.pdf
Key pattern to get Prompt Access Tone. (Maximum 20 digits. No default)
If set to "Yes", the configuration update via keypad is disabled.
Disables the voice prompt configuration. Default is "No". If set to "Yes" accessing
integrated voice menu will be impossible.
Disables the Direct IP Call function. Default is "No". If set to "Yes" direct IP-to-IP
calling will not be supported.
GXW40XX USER MANUAL
Page 39 of 60

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gxw-4008Gxw-4024

Table of Contents