Table of Contents
Advertisement
Examples:
a) If the target IP address is 192.168.0.160, the dialing convention is
*47 or Voice Prompt with option 47, then 192*168*0*160.
followed by pressing the "#" key if it is configured as a send key or wait 4 se conds. In this case,
the default destination port 5060 is used if no port is specified
b) If the target IP address/port is 192.168.1.20:5062, then the dialing convention would be:
*47 or Voice Prompt with option 47, then 192*168*0*160*5062 followed by pressing the "#" key
if it is configured as a send key or wait for 4 seconds.
NOTE: When completing direct IP call, the "Use Random Port" should set to "NO". You can not make
direct IP calls between FXS ports since they are using same IP.
C
H
ALL
OLD
Place a call on hold by pressing the "flash " button on the analog phon e (if the phone has that button).
Press the "flash" button again to release the previously held Caller and resume conversation. If no "flash"
button is available, use "hook flash" (toggle on-off hook quickly). You may drop a call using hook flash.
C
W
ALL
AITING
Call waiting tone (2 sh ort beeps) indicates an incoming call, if the call waiting feature is ena bled. Toggle
between incoming call and current call by pressing t he "flash" button. First call is placed on hold. Press
the "flash" button to toggle between two active calls.
C
T
ALL
RANSFER
BLIND TRANSFER
Assume that call Caller A and B are in conversation. A wants to Blind Transfer B to C:
3. Caller A presses FLASH on the analog phone to hear the dial tone.
4. Caller A dials *87 then dials caller C's number, and then # (or wait for 4 seconds).
5. Caller A will hear the confirm tone. Then, A can hang up.
NOTE: "Enable Call Feature" must be set to "Yes" in web configuration page.
Caller A can place a call on hold and wait for one of three situations:
1. A quick confirmation tone (similar to call waiting t one) followed by a dial tone. This indicates the
transfer is successful (transferee has received a 200 OK from transfer target). At this point,
Caller A can either hang up or make another call.
2. A quick bu sy tone followe d by a resto red call (on supported platforms only). This means the
transferee has received a 4xx response for the I NVITE and we will try to re cover the call. The
busy tone is just to indicate to the transferor that the transfer has failed.
Continuous busy tone. The phone has timed out. Note: continuous busy tone does not indicate
3.
the transfer has been successful, nor does it indicate the transfer has failed. It often means there
was a failure to receive second NOTIFY – check firmware for most recent release.
ATTENDED TRANSFER
Assume that Caller A and B are in conversation. Caller A wants to Attend Transfer B to C:
1. Caller A presses FLASH on the analog phone for dial tone.
2. Caller A then dials Caller C's number followed by # (or wait for 4 seconds).
Grandstream Networks, Inc.
GXW40XX User Manual
Firmware 1.0.5.10
.
Page 14 of 40
Last Updated: 01/2012
Advertisement
Table of Contents
