Grandstream Networks GXW-4004 User Manual page 34

NAT UDP timeout
Uplink Bandwidth
Downlink Bandwidth
Enable UPnP support
Reply to ICMP on WAN port
WAN side HTTP/Telnet
Access
Cloned WAN MAC Address
Enable LAN DHCP
LAN Subnet Mask
LAN DHCP Base IP
LAN DHCP Start IP
LAN DHCP End IP
FIRMWARE VERSION 1.0.9.1
NAT UDP timeout in seconds.
Note: This option is not present on GXW4024
ISP specified WAN uplink bandwidth
Note: This option is not present on GXW4024
ISP specified WAN downlink bandwidth
Note: This option is not present on GXW4024
If set to "Yes", the GXW40XX would act as an UPnP gateway for your UPnP enable
applications. UPnP - Universal Plug n Play
Note: This option is not present on GXW4024
If set to "Yes", the GXW40XX will respond to the PING. Default is No.
"Yes" setting may make the gateway vulnerable to a
Note: This option is not present on GXW4024
If set to "Yes", user can access the configuration page through the WAN port,
instead of through the "PC" port. WARNING: this configuration is less secure than
default option. Default is No.
Note: This option is not present on GXW4024
This allows you to change/set the MAC address on the WAN interface.
Note: This option is not present on GXW4024
Default is Yes.
Note: This option is not present on GXW4024
Sets the LAN subnet mask. Default value is 255.255.255.0
Note: This option is not present on GXW4024
Base IP for the LAN port which functions as a Gateway for the subnet.
Default value is 192.168.2.1.
When the device detects WAN IP is conflicting with LAN IP, the LAN base IP
address will be changed based on the network mask -- the effective subnet will be
increased by 1. For example; 192.168.2.1 will be changed to 192.168.3.1 if net
mask is 255.255.255.0. Then the device will reboot
Note: This option is not present on GXW4024
Default is 100
Note: This option is not present on GXW4024
Default is 199
Note: This option is not present on GXW4024
GXW40XX USER MANUAL
Denial of Service attack.
Page 34 of 60