Qlogic Fibre Channel Switch Event Message Manual page 71

Firmware version 7.4/7.8
Hide thumbs Also See for Fibre Channel Switch:
Table of Contents

Advertisement

A
(C) (8700.000F) (EPort) (Port: port_number) (Broadcast frame received & broadcast
disabled, discarding broadcast frames.)
Meaning:
(C) (8700.0010) (EPort) (Port: port_number) (Inter-Switch Link (ISL) unstable. ISL init will be
held back until ISL up time is 5 seconds)
Meaning:
(C) (8700.0011) (Eport) (Port: port_number) (Connection failure, remote switch not
compatible)
Meaning:
(C) (8700.0012) (Eport) (Port: port_number) (Connection failure, fabric limited to two
switches)
Meaning:
(C) (8700.0013) (Connection failure, fabric limited to two switches)
Meaning:
(C) (8B00.0005) (Unable to test profile profile because the CallHome service is disabled)
Meaning:
(C) (8B00.0006) (Unable to test profile because the CallHome service is disabled)
Meaning:
(C) (8B00.0007) (Unable to test profile profile because the FromEmailAddress has not been
configured in the CallHome setup)
Meaning:
(C) (8B00.0008) (Unable to test profile profile because the CallHome service is updating
configuration)
Meaning:
59060-06 A
Broadcast is disabled and the switch has received a broadcast
frame. Enable broadcast to receive broadcast frames.
The ISL is unstable, indicating that the media module or the cable
is bad.
The remote switch is not compatible with the local switch. The
E_Port cannot exchange switch capabilities with the remote switch.
The switch cannot be connected to the fabric due to a license
restriction.
The switch cannot be connected to the fabric due to license
restriction.
The test of the named profile failed because the Call Home service
is disabled.
The test of the named profile failed because the Simple Mail
Transfer Protocol (SMTP) server IP addresses are the factory
defaults or the servers are disabled in the Call Home service
configuration.
The test of the named profile failed because the
FromEmailAddress was not specified in the Call Home service
configuration.
The profile cannot be tested while the Call Home service
configuration is being updated.
3 – Event Messages
Critical Events
3-59

Advertisement

Table of Contents
loading

Table of Contents