Qlogic Fibre Channel Switch Event Message Manual page 49

A
(A1007.0023) (Invalid response authenticator from RADIUS server IP_address:port, check
shared secret
Meaning:
Action:
(A1007.0024) (Invalid access accept from RADIUS server IP_address:port, bad or missing
Service-Type)
Meaning:
Action:
(A1007.0025) (Security feature not supported.)
Meaning:
Action:
(A1007.0026) (Unable to validate Chap Response from device_WWN, possible Chap secret
misconfiguration or security breach attempt.)
Meaning:
Action:
(A1007.0027) (Radius server could not validate authentication response from port_number)
Meaning:
Action:
(A1007.0028) (Security: 2-Way Authentication, No security entry found for port)
Meaning:
Action:
59060-06 A
There is a Remote Authentication Dial In Service (RADIUS)
configuration problem.
Confirm that the shared secret configured on the switch is identical
to the shared secret configured on the RADIUS server.
A service-type Remote Authentication Dial In Service (RADIUS)
attribute was not found in a RADIUS packet.
This is a RADIUS server configuration issue. Consult your RADIUS
server documentation.
The switch is coming out of Non-Disruptive Code Load and
Activation (NDCLA) and had an active security prior to the NDCLA,
but the security feature is no longer supported.
A license key may be required for the security feature.
A Challenge Handshake Authentication Protocol (CHAP)
authentication attempt failed due to failure while comparing
secrets.
Check security configuration.
Remote Authentication Dial In Service (RADIUS) authentication
failed.
Confirm that the secret is the same on the switch as it is on the
RADIUS server.
Unable to locate a security member entry to complete a two-way
authentication.
Edit the group to include the port.
3 – Event Messages
Alarm Events
3-37